User guide

Appendix B. Hardware Installation
B-2
Figure 24. Installed SIM Card
B.2 Antenna Installation
These instructions apply to both the Base and Remote stations. This installation
does not have to precede the modem installation. It should be conducted in the
most convenient and logical order.
The installation of the antenna and cable should begin with securing the Nu-rail to
the threaded pipe supplied, and then feed the antenna cable through the threaded
pipe (Figure 25). Next loosen the four Phillips screws at the base of the antenna
and separate the two pieces. Feed the antenna cable through the bottom half and
secure the cable to the connector of the other half (Figure 26). Once the cable is in
place, reattach the bottom half of the antenna and secure the four Phillips screws.
Be sure to use the alignment notches on the two halves before securing the
antenna together.
Figure 25. Antenna Mount and Cabling
Installed
SIM Card
Card
Notch
L
1
1
8
0
T
h
r
e
a
d
e
d
P
i
p
e
L
1
0
1
7
N
u
-
r
a
i
l
Supplied
Threaded Pipe
008158
Nu-rail