User guide

B-1
Appendix B. Hardware Installation
The hardware shown in this Appendix consists only of hardware listed in Table 1.
Although it may be possible to use other hardware, it will not be addressed in this
Appendix.
Do not connect power to either modem until installation is
complete, as damage to the equipment may occur.
B.1 SIM Card Installation
These installation steps apply to both the Base and Remote modems. Be sure that
the correct card is installed in the proper modem. Start by removing the cover on
the top of the modem (Figure 22). This will require the use of either a 5/64 Allen
Key.
Open the card slot by pushing the card holder away from the end labelled “Lock”,
until it is able to flip up. Place the card in the slot in the proper orientation shown
in Figure 22. The card notch will need to line up with the notch of the card slot.
Close and lock the card slot into place (Figure 23 & 24). Once complete, replace
the housing cover.
Figure 22. SIM Card Housing
Figure 23. SIM Card Slot
WARNING