User guide

User Guide
17
Figure 19. PakBus Port Configuration
5.1.6 Step 6: CR1000 Configuration
Be sure that the Communications Enabled box is checked and that the PakBus
Address is correct for the datalogger being used. Add 200 ms under Delay Hangup
(Figure 20).
Configure the Scheduled Collection interval as required for your application. Be sure
that the Scheduled Collection Enabled box is checked. Figure 21 shows an example
of a daily scheduled data collection that is to start at 1:00pm. The number of retries
and the retry interval are left in their default state in the example. These values
should be adjusted as required.
Once all configuration are complete click the Apply button in the lower left hand
corner. The station is now set up in LoggerNet.