Instruction manual

CD100 Mountable Display with Keypad
5. Specifications
Features:
• Operable with gloved hand
• 16 key alpha numeric keypad
• 8 line x 21 character display (64 x 128 pixel)
Compatibility: CR800 (not CR850)
CR1000
CR3000
Interface: CS I/O, SDC address 2
Temperature
Operating: –45° to 85°C
Storage: –50° to 85°C
Transit: 1 hour at –60°C
Power Requirement
Source: 12 Vdc from datalogger CS I/O port
Current Draw
Inactive: 0.02 mA
Active: 140 mA
Certification: CE Compliant
Rating
Water and dust ingress
Installed as
recommended: IP66
Uninstalled: None (vulnerable to water and dust)
Weight: 0.36 kg (0.80 lb)
Dimensions: 176 x 138 x 8 mm (6.9 x 5.4 x 1.4 in)
6. Installation
As a purchased service, Campbell Scientific offers the option of installing
the CD100 into an enclosure.
Install only on a flat, non-porous surface. The supplied gasket must create a
weather-tight seal when installed or permanent damage to the display and other
enclosure contents may occur.
1. Use the template shipped with the CD100 or create a template using the
measurements shown in FIGURE 6-1, Template Measurements.
2. Make the required cuts in the bulkhead.
3. Remove cutting debris from bulkhead.
4. Mount the CD100 as shown in FIGURE 6-2, Profile of Installed CD100.
NOTE
3