Specifications

ISU AT Command Reference Phase I AT Commands
Iridium Proprietary Version 2.45
20 June 2011 30
5.58 +CR - Service Reporting Control
Set Command: +CR=[<mode>]
Set the service reporting level.
<mode> takes the following values:
0 Disable reporting (default).
1 Enable reporting.
If reporting is enabled, the intermediate result code
+CR: <serv> is returned by the ISU.
<serv> can have one of the following values:
ASYNC asynchronous transparent
SYNC synchronous transparent
REL ASYNC asynchronous non-transparent
REL SYNC synchronous non-transparent
Read Command: +CR?
Query the current service reporting level settings. The response is in the form:
+CR: <mode>
Test Command: +CR=?
List the supported reporting levels. The response is in the form:
+CR: (supported <mode>s)
5.59 +CRC - Cellular Result Codes (Initial implementation; revised in Phase III)
Set Command: +CRC=[<mode>]
Set the extended format of incoming data call indication.
<mode> takes the following values:
0 Disable extended format (default).
1 Enable extended format.
If extended format is enabled, the unsolicited result code
+CRING: <type> is returned by the ISU instead
of
RING, where <type> can be one of the following:
ASYNC asynchronous transparent
SYNC synchronous transparent
REL ASYNC asynchronous non-transparent
REL SYNC synchronous non-transparent
Read Command: +CRC?
Query the current result code settings. The response is in the form:
+CR: <mode>
Test Command: +CRC=?
List the supported result code settings. The response is in the form:
+CR: (supported <mode>s)