Specifications

ISU AT Command Reference Phase I AT Commands
Iridium Proprietary Version 2.45
20 June 2011 19
5.14 Nn - Automode Enable
Enable or disable automode detection.
No action, compatibility only.
Any value for n is accepted.
5.15 On - Online
Enter in-call data mode. This is used to return to in-call data mode from in-call command mode using an
existing connection. An error is reported if on-hook.
0 Switch from in-call command mode to in-call data mode.
Any value for n accepted.
5.16 P - Pulse Dial
Set pulse dial.
No action, compatibility only.
5.17 Qn - Quiet Mode
Control ISU responses.
0 ISU responses are sent to the DTE (default).
1 ISU responses are NOT sent to the DTE.
5.18 S0=n - Auto-Answer (Initial implementation; revised in Phase III)
Auto-answer. This causes the ISU to auto-answer the incoming data call.
0 Disable auto-answer.
n>0 Enable auto-answer.
5.19 T - Tone Dial
Set tone dial.
No action, compatibility only.