Instruction manual
9522B Iridium Satellite Modem
_____________________________________________________________________________
21
4. Remote Modem Configuration
As a matter of system redundancy it is recommended that the
following programming be used as part of your datalogger
program. If this programming is not used it is possible that the
remote modem may lose it’s configuration. If this occurs remote
communication will no longer be available.
The program example is for a CR1000, but is adaptable to the
CR800 series, and CR3000 dataloggers. The example is for a
solar powered site where power management is a concern.
Modem power is controlled by the C2462 via Control port 1. The
modem is powered up twice per day for 15 minutes each time.
During this time the modem is sent it’s configuration via the CS
I/O port and the remainder of the time is used for actual
communications.
For details on programming for the CR10X contact Campbell
Scientific. Please note that the interface between the CR10X and
the C2462 requires the use of SC932A CS I/O to RS232 DCE
interface.
58777%&' #%
5 %( % &
5% &#%%(!#"(%'#"
( '($'%&'%"3<8
( #"(%4!#!&## "
5"%#%!
"%#
5"&(%'#"'%# $#%'(&'#'%%$#*%'#'!#!&&'&"#('$('/
5"'&+!$ #"'%# $#%'8&(&'#'(%"$#*%#"0##%'!#!/
#%''18.82
#%''18.72
"1<..:.72
5')'%(!#!&'##"-"' ,#%8<!"('&'!/
5 #*!#!*%!($'!-&''"&1<!"('&2-''%"&!&&#"&187
!"('&2
5333&"'%) &''%$$ #%,#(%$$ '#"333
!"'#"'%) 1>8<.>97."2"#%''18.82
!"'#"'%) 187.>97."2"#%''18.72
5 #*'!#!8!"('#%*%!($#%&""&''"&/"&''"&%
5&"''#'!#! #*"#'%;!"('&'#"&(%'!#!&%&'%#"
5'"'*#%#%''!$'"#!!("'#"&/
!1>8=.>97.!"2"#"(%4!#!A'%(
#"(%4!#!A'%("