Instruction manual

9522B Iridium Satellite Modem

_____________________________________________________________________________

2.2.5. Step 5: Configuring Port Settings

Select 19200 bits per second (Baud rate) if you are using a

modem set at 19200 Baud, which is recommended for the

CR800 series, the CR1000, and CR3000 dataloggers (Figure 9).

Note that the modems by default are set to autobaud. Click

Apply, and then click OK.

Note: The datalogger being used at the remote station will dictate

which baud rate will be used. For example if you are using a

CR10X, then you will set the modem to 9600 Baud.

Figure 9: Port Settings Configured

2.2.6. Step 6: Hyperterminal Communications

Once you have clicked OK you should be connected to the

modem (Figure 10). The counter in the bottom left hand corner of

the screen will inform you that you are connected and begin

counting up from 0.