Specifications

ENC10/12, ENC12/14, ENC14/16, ENC16/18

3. Mounting Equipment Inside the Enclosure

3.1 Enclosures with One or Two 1.5” Conduits

1. If installing the optional Door Switch Indicator, follow the procedure

described in Appendix A.

2. If installing the 25458 DIN-Rail Terminal Kit, follow the procedure

described in Appendix B. The 25458 kit facilitates wiring when many

wires need to be connected to one terminal.

3. Use the #6 screws and plastic grommets (Figure 3-1A) to mount additional

peripherals to the enclosure backplate (Figure 3-1B). Dataloggers, power

supplies, and most peripherals are usually attached to the backplate prior to

shipment from the factory or are supplied with additional screws and

grommets.

To insert the grommet, push the points of the flanges into the center of any

square hole. To remove a grommet without damage, remove the enclosure

backplate and use pliers to pinch the grommet flanges together.

FIGURE 3-1. Securing Components to the Enclosure Backplate

Remember to allow space for cables and cable connectors.

NOTE