Specifications
Enclosures Table of Contents
B. 25458 DIN-Rail Terminal Kit.................................... B-1
B.1 Introduction ......................................................................................... B-1
B.2 Installation Procedure.......................................................................... B-1
C. Reusing Desiccant ..................................................C-1
C.1 Recirculating Oven Method ................................................................ C-1
C.2 Standard Oven Method........................................................................ C-1
C.3 Baby Food Jar Method ........................................................................ C-1
Figures
2-1. Components of the enclosure supply kit; screwdriver and PVC
coupling not shown ........................................................................ 2
3-1. Securing Components to the Enclosure Backplate................................. 3
3-2. Securing Cables to the Cable Tie Tabs................................................... 5
3-3. An ENC12/14 with one 1.5” conduit houses a CR1000 datalogger
and BP24 power supply. Door not shown .................................... 6
3-4. Cable Inserted into Compression Fitting ................................................ 7
3-5. This ENC16/18 enclosure with the “-ES” option houses the
equipment commonly used in a GOES satellite system................. 8
4-1. An enclosure with the “-MM” mounting option attaches to a tripod
mast via u-bolts .............................................................................. 9
4-2. This exploded view shows the components of a “-MM” bracket........... 9
4-3. An enclosure attached to a tripod mast................................................. 10
4-4. Enclosure brackets configured for a tower mount................................ 11
4-5. This exploded view shows the components of a “-TM” bracket
option ........................................................................................... 12
4-6. An enclosure attached to two tower legs .............................................. 12
4-7. The 19124 bracket attached to a CM110 tripod ................................... 14
4-8. An ENC14/16 enclosure with a “-LM” Bracket................................... 14
4-9. The u-bolt bracket................................................................................. 15
4-10. An enclosure attached to the leg base of a CM110 tripod .................. 15
4-11. Mounting Two Enclosures on a Single Tripod Leg............................ 16
4-12. Attaching the Pole Mount Bracket ..................................................... 17
4-13. Inserting the Metal Band .................................................................... 17
4-14. Securing the Enclosure to a Pole ........................................................ 18
A.1-1. This procedure is for ENC16/18 enclosures that do NOT have
an offset near the edge of the enclosure door............................. A-1
A.1-2. The proper placement of the screw holes are shown in a
close-up and distant view........................................................... A-1
A.1-3. Switch installed in the enclosure case............................................. A-2
A.1-4. Actuator installed in the enclosure door ......................................... A-2
A.1-5. Customers with ENC16/18 enclosures should use this procedure
if their enclosure has an offset near the edge of the enclosure
door as shown in the photograph ............................................... A-3
A.1-6. The proper placement of the screw holes are shown in a close-up
and distant view ......................................................................... A-3
A.1-7. Place the #18431 switch on the #18176 bracket with the holes
of switch located over the bracket tabs ...................................... A-4
A.1-8. Secure the #18431 switch with the #18177 back bracket............... A-4
A.1-9. The switch mounts inside the enclosure case ................................. A-5
A.1-10. The actuator mounts inside the enclosure lid................................ A-5
A.1-11. The proper placement of the screw holes are shown .................... A-6
A.1-12. Assemble the mounting bracket as shown.................................... A-6
A.1-13. Securing the actuator .................................................................... A-7
A.1-14. The actuator attached to the enclosure door ................................. A-7
ii