Specifications

Appendix A. Door Switch
A.1.3 ENC12/14 and ENC10/12
1. Mark locations to drill on the upper right side of the enclosure as shown in
Figure A.1-11.
2. Using a #22 (.157) drill, drill pilot hole from inside of case and final hole
from outside of case so that enclosure finish does not crack.
FIGURE A.1-11. The proper placement of the screw holes are shown. Ensure both brackets are
aligned with each other.
3. Assemble the mounting bracket as shown in Figure A.1-12.
FIGURE A.1-12. Assemble the mounting bracket as shown.
A-6