Specifications

Appendix A. Door Switch
A.1.2 ENC14/16 and Older ENC16/18 (see Figure A.1-5)
Offse
t
Offset
FIGURE A.1-5. Customers with ENC16/18 enclosures should use this
procedure if their enclosure has an offset near the edge of the
enclosure door as shown in the photograph.
1. Mark locations to drill on the upper right side of the enclosure as shown in
Figure A.1-6.
2. Using a #22 (.157) drill, drill pilot hole from inside of case and final hole
from outside of case so that enclosure finish does not crack.
FIGURE A.1-6. The proper placement of the screw holes are shown in a close-up (left photo) and
distant view. Ensure that the screw holes for both brackets are aligned with each other.
A-3