Specifications

ENC10/12, ENC12/14, ENC14/16, ENC16/18

FIGURE 3-3. An ENC12/14 with one 1.5” conduit houses a CR1000 datalogger

and BP24 power supply. Door not shown.

3.2 Enclosures with Individual Compression Fittings

1. If installing the optional Door Switch Indicator, follow the procedure

described in Appendix A.

2. Use the #6 screws and plastic grommets (Figure 3-1A) to mount additional

peripherals to the enclosure backplate (Figure 3-1B). Dataloggers, power

supplies, and most peripherals are usually attached to the backplate prior

to shipment from the factory or are supplied with additional screws and

grommets.

To insert the grommet, push the points of the flanges into the center of any

square hole. To remove a grommet without damage, remove the enclosure

backplate and use pliers to pinch the grommet flanges together.

Remember to allow space for cables and cable connectors.

NOTE