Instruction Manual

TurfWeather Weather Station

involved, and this procedure can be accomplished by anyone possessing basic

mechanical skills. Please read this entire procedure before beginning work.

Tools Required:

• 1/2-inch wrench

• 5/16-inch wrench

• #2 Phillips screwdriver

• Small wire cutter

pn 18914 Auxiliary Battery Unit kit components:

• Enclosure with 7 Ah battery

• 18971 Battery Cable

• U-bolt, washers and brass nuts

1. Remove the internal battery:

a. Follow step 1 in Section 6.9.2, Battery Pack Replacement Procedure.

b. Reinstall bracket and screws without battery.

2. Wiring modifications:

a. Locate the yellow wire marked Batt + and remove the protective tape.

b. Locate the terminal marked Battery + on the circuit board and open

the connector lever. Install the yellow wire marked Batt + into this

connector and close the lever (FIGURE 5-19).