Owner's manual
Table Of Contents
- Revision and Copyright Information
- Limited Warranty
- Assistance
- Table of Contents
- 1. Preparation and Siting
- 2. Hardware Installation
- 2.1 Base Foundation
- 2.2 Tower/Pole
- 2.3 Enclosure
- 2.4 Crossarm and Sensor Installation
- 2.5 Communication Peripherals
- 2.6 Lightning Rod Installation
- 2.7 Solar Panel Installation
- 2.8 Battery Installation
- 2.9 Restraining Cables and Sealing/Desiccating Enclosure
- 3. ET Software
- 4. Maintenance, Troubleshooting, and Schematics
- 4.1 Maintenance
- 4.2 Troubleshooting
- 4.2.1 No Response Using the CR1000KD Keypad
- 4.2.2 No Response from Datalogger through SC32B, RAD Modem, or Phone Modem
- 4.2.3 NAN or (INF Displayed in a Variable
- 4.2.4 Unreasonable Results Displayed in a Variable
- 4.2.5 NAN or (INF Stored in a Data Table
- 4.2.6 Communication Problems when using an RF450 Radio
- 4.2.7 Gill WindSonic1-ET Diagnostic Diagnostic Codes
- 4.3 Schematics of Connectors
- Appendix A. T107 Maintenance Log
- Appendix B. PS24 24 Ahr Power Supply and 10 x 12 inch Enclosure
- Appendix C. Exploded Views
- Appendix D. Default Programs
- Appendix E. Step-down Transformer Installation
- Campbell Scientific Companies
Appendix A. T107 Maintenance Log
CLEAN/INSPECT
SOLAR RADIATION SENSOR
(Recommended - Monthly)
Date OK/Comments
CLEAN/INSPECT TEMP/% RH
SENSOR & GILL RADIATION SHIELD
(Recommended - Quarterly)
Date OK/Comments
REPLACE WIND SPEED BEARINGS AND
REED SWITCH
(Recommended - Yearly)
Date OK/Comments
REPLACE RH CHIP (pn 9598) IN THE
HMP60-ETS TEMP/% RH SENSOR
(Recommended - Yearly)
Date OK/Comments
REPLACE DESICCANT BAGS (QTY - 2
OF pn 4905) INSIDE ENCLOSURE
(Recommended - Yearly)
Date OK/Comments
CALIBRATE SOLAR RADIATION
SENSOR (CS305-ET)
(Recommended - Every 3 Years)
Date OK/Comments
A-2