Owner's manual
Table Of Contents
- Revision and Copyright Information
- Limited Warranty
- Assistance
- Table of Contents
- 1. Preparation and Siting
- 2. Hardware Installation
- 2.1 Base Foundation
- 2.2 Tower/Pole
- 2.3 Enclosure
- 2.4 Crossarm and Sensor Installation
- 2.5 Communication Peripherals
- 2.6 Lightning Rod Installation
- 2.7 Solar Panel Installation
- 2.8 Battery Installation
- 2.9 Restraining Cables and Sealing/Desiccating Enclosure
- 3. ET Software
- 4. Maintenance, Troubleshooting, and Schematics
- 4.1 Maintenance
- 4.2 Troubleshooting
- 4.2.1 No Response Using the CR1000KD Keypad
- 4.2.2 No Response from Datalogger through SC32B, RAD Modem, or Phone Modem
- 4.2.3 NAN or (INF Displayed in a Variable
- 4.2.4 Unreasonable Results Displayed in a Variable
- 4.2.5 NAN or (INF Stored in a Data Table
- 4.2.6 Communication Problems when using an RF450 Radio
- 4.2.7 Gill WindSonic1-ET Diagnostic Diagnostic Codes
- 4.3 Schematics of Connectors
- Appendix A. T107 Maintenance Log
- Appendix B. PS24 24 Ahr Power Supply and 10 x 12 inch Enclosure
- Appendix C. Exploded Views
- Appendix D. Default Programs
- Appendix E. Step-down Transformer Installation
- Campbell Scientific Companies

T107 Weather Station
FIGURE 2-47. Desiccant Installation
3. ET Software
The T107 comes with a default program, and typically does not
require additional programming (see Appendix D).
A variety of different software packages are available to work with the T107
station. This section introduces software packages that can be used with the
T107 station. It is not the goal to fully explain capabilities of each package. All
software packages mentioned below come with extensive help files. Contact
Campbell Scientific with questions and support. All software includes
installation instructions.
For Toro T.Weather 3.0 or higher, contact Toro NSN for support at (800) 275-
8676.
PC200W is free software which is used to communicate with a direct connect
or short-haul modem station and collect data. PC200W software cannot be used
to communicate with stations on a phone modem. This software can be
downloaded from Campbell Scientific’s website www.campbellsci.com.
NOTE
Desiccant
54










