Instruction Manual

Appendix I. Phone to RF401 Series
If there is a neighboring RF401 network, you should change the
Hopping Sequence of base and remote RF401s to a new setting to
avoid interference.
- RX LED Test -
To determine if there is a neighboring RF401 network in operation
using the same hopping sequence as yours, stop communications on
your network and observe RF401 green LEDs for activity. At this
point, any green LED activity would indicate that there is a nearby
network using the same hopping sequence.
3. POINT-TO-MULTIPOINT COMMUNICATIONS (Transparent Protocol)
PC-Modem --------- COM220-A100/PS100-RF401 --------- RF401-DL1
------------ RF401-DL2
LoggerNet SETUP
a. Setup:
ComPort_1
PhoneBase
PhoneRemote
RF401
RF401Remote
CR10X
RF401Remote_2
CR10X_2
b. ComPort_1 – default settings
c. PhoneBase
1) Maximum Baud Rate – 9600
2) Modem Pick List – per PC’s phone modem
3) Extra Response Time – 0 s
d. PhoneRemote – input base site’s phone number
e. RF401 – make Attention Character: “-“ ; leave the rest defaults
f. RF401Remote – make Radio Address: “1“ ; leave the rest defaults
g. RF401Remote_2 – make Radio Address: “2“ ; leave the rest defaults
h. Dataloggers – default settings, schedule collections as desired
RF401 CONFIGURATION
a. Base RF401
1) Active Interface: ME Master
2) Protocol: Transparent
3) CS I/O ME Baud Rate: 9600
4) All other settings: defaults
NOTE
I-8