Redwing105 AirLink CDMA Modem C3111 Revision: 7/06 C o p y r i g h t © 2 0 0 4 - 2 0 0 6 C a m p b e l l S c i e n t i f i c , I n c .
Warranty and Assistance The REDWING105 AIRLINK CDMA MODEM C3111 is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under normal use and service for twelve (12) months from date of shipment unless specified otherwise. Batteries have no warranty. CAMPBELL SCIENTIFIC, INC.'s obligation under this warranty is limited to repairing or replacing (at CAMPBELL SCIENTIFIC, INC.'s option) defective products.
Redwing105 CDMA Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to specific sections. 1. Introduction..................................................................1 2. Specifications ..............................................................1 2.1 Base Station Requirements .......................................................................1 2.2 Datalogger Site Equipment...........................
This is a blank page.
Redwing105 AirLink CDMA Modem 1. Introduction Redwing modems are full-duplex, digital cellular modems that communicate with a base station PC via Code Division Multiple Access (CDMA) network and Public Switched Telephone Network (PSTN). Redwing105 modems are for use on the Alltel network only. 2. Specifications 2.1 Base Station Requirements • PC with Hayes-compatible modem, running Campbell Scientific’s LoggerNet or PC400 software.
Redwing105 AirLink CDMA Modem 2.3 Power Considerations • A power cable included with the modem connects to the datalogger's 12 V or switched 12 V terminal. Connection to the switched 12 V terminal allows the datalogger to switch power to the modem during scheduled transmission intervals if desired. • When using the switched 12 V terminal, the modem can be powered with a BP12 battery, CH100 charger/regulator, and MSX10 solar panel. 3. Configuration 3.
Redwing105 AirLink CDMA Modem 5. Enter the MDN. 6. Enter the MIN. 7. Press the “Start” button to program the phone. 3.3 Setup LoggerNet NOTE 1. Select Add Root | TapiPort. 2. Add a TapiRemote to the TapiPort. 3. Add a datalogger to the TapiRemote. 4. On the TapiPort page, select your installed modem on the Tapi Line. 5. On the TapiRemote un-check “Use Tapi Dialing Properties.“ 6. Enter the phone number of the CDMA phone. 7. Apply the changes and test.
Redwing105 AirLink CDMA Modem This is a blank page.
Appendix A. Configuring Modem with a Terminal Emulator NOTE Programming the modem with a terminal emulator is not recommended. Please first attempt programming with the CellWizard.exe program available from Campbell Scientific, Inc. Items needed: • Computer with a COM port. • 9-pin cable to connect between the computer and the Redwing. • A terminal program on the computer “HyperTerminal”. • 12 volt DC applied to the Redwing. • Antenna on the Redwing (for over-the-air updates). • CDMA account.
Appendix A. Configuring Modem with a Terminal Emulator Apply power to the modem and connect it to the computer via the 9-pin serial cable. A.2 Programming the Redwing’s Phone Number Your provider should give you two numbers to program into the Redwing, the MDN (Mobile Directory Number) and MIN (Mobile Identification Number). Perform the following steps substituting the MDN and MIN with yours. AT Commands to be typed are in bold.
Appendix A. Configuring Modem with a Terminal Emulator A.3 Programming the Redwing for Use with a Datalogger The Redwing needs a few settings changed in it to power-up ready to work with the datalogger. Step AT Commands Response 6 ATS0=1+CICB=0 OK Description Sets auto answer in data mode. 7 AT+IFC=0,0 OK Disables local flow control. Sets the Redwings RS232 baud rate and saves settings.
Appendix A. Configuring Modem with a Terminal Emulator This is a blank page.
This is a blank page.
Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbellsci.com Campbell Scientific Africa Pty. Ltd. (CSAf) PO Box 2450 Somerset West 7129 SOUTH AFRICA www.csafrica.co.za sales@csafrica.co.za Campbell Scientific Australia Pty. Ltd. (CSA) PO Box 444 Thuringowa Central QLD 4812 AUSTRALIA www.campbellsci.com.au info@campbellsci.com.au Campbell Scientific do Brazil Ltda.
