Manual

ET107 Weather Station

FIGURE 2-24. Position of sensor bulkhead connectors

It’s very important that each plug is completely seated on to the

connector and the locking ring turned 1/4 revolution clockwise.

Failure to seat the plug completely could cause corrosion and

water damage to both the enclosure and the sensor cable.

Notice how the sensor caps are slid between the connector and the

one above in FIGURE 2-25. This will keep the caps out of the

way of the connector cover.

NOTE

Enclosure Ground Lug

Sensors

TEMP CS616

WS/WD

SDI

-12

TEMP/SONIC

RAIN (PRECIP)

TEMP/RH

SOLAR RADIATION

COMM

POWER

BNC Coaxial

Connector

Standoff

Wire Tie Harness