Manual

ET107 Weather Station
1.2 Installation Tasks
1.2.1 Indoors
• Immediately upon receipt of your shipment…
⇒ Weather station is packed in the shipping box in layers. See FIGURE
1-2, FIGURE 1-3, FIGURE 1-4, and FIGURE 1-5.
⇒ Immediately upon receipt of your shipment…
Open shipping carton(s).
Set the large weather station carton down lengthwise on a floor or
table top. Position the box as shown in FIGURE 1-2.
Cut the tape along the edge of the lower flap first. See FIGURE 1-2.
Cut the tape around the remaining flaps BUT only cut one layer deep.
Lift up the cardboard flaps exposing the top layer of foam as shown in
FIGURE 1-3.
⇒ Check contents against invoice and shipping checklist. Contact CSI
immediately about any shortages.
FIGURE 1-2. Cut flap packing tape
FIGURE 1-3. Shipping box packaging
Top Packing
Foam Layer
Middle Packing
Foam Layer
Bottom Packing
Foam Layer
ET107,
Top Layer
ET107,
Bottom Layer
Cut Lower Flap
Edge First
3