Owner's manual
Table Of Contents
- Revision and Copyright Information
- Warranty
- Assistance
- Table of Contents
- 1. General Description
- 2. Enclosure Supply Kit
- 3. Mounting Equipment Inside the Enclosure
- 4. Attachment to an Instrument Mount
- 5. When to Replace Desiccant
- 6. Resistance to Weathering
- Appendix A. Door Switch
- Appendix B. 25458/28532 DIN-Rail Terminal Kits
- Appendix C. 28960 Stack Mounting Kit
- Appendix D. Keeping Insects Out Of the Enclosure
- Campbell Scientific Companies
Appendix C. 28960 Stack Mounting Kit
C-4
C.2 Mounting Procedure
1. Determine the spacing needed between the two legs.
2. Secure the legs to the back plate using screws and grommets. If a
component is to be mounted under another and shares the same mounting
holes as the leg, mount the pieces in the following order.
Back Plate < Grommet < Leg < Component < Screw
3. Fully wire the bottom component before proceeding.
4. Place the Top Grid in position over the Legs. Insert Grommets where
required for the component to be mounted. If the Top Grid is not going to
be used, insert the Grommets directly into the top of the Legs.
5. Place the top component in position and secure it with Screws.