User guide

EasyAG
®
Soil Water Content Profile Probes
;Load measurement failure errors
13: If (X<=>F) (P89) ;Measurement of 0 at 1st sensor
1: 1 X Loc [ ES1_SF_1 ] ;indicates an inactive probe.
2: 1 = ;
3: 0 F
4: 30 Then Do
14: Z=F x 10^n (P30) ;Set 1st sensor reading to -99999
1: -99999 F
2: 0 n, Exponent of 10
3: 1 Z Loc [ ES1_SF_1 ]
15: End (P95)
16: Beginning of Loop (P87) ;Loop to set error codes
1: 0 Delay
2: 8 Loop Count
17: If (X<=>F) (P89) ;If 1st sensor reading is < -9999 i.e. = -99999
1: 1 X Loc [ ES1_SF_1 ] ;then set all sensor readings to -99999
2: 4 <
3: -9999 F
4: 30 Then Do
18: Z=F x 10^n (P30)
1: -99999 F
2: 0 n, Exponent of 10
3: 1 -- Z Loc [ ES1_SF_1 ]
19: Z=F x 10^n (P30)
1: -99999 F
2: 0 n, Exponent of 10
3: 9 -- Z Loc [ ES1_WC_1 ]
20: Z=F x 10^n (P30)
1: -99999 F
2: 0 n, Exponent of 10
3: 17 -- Z Loc [ ES1_VIC_1 ]
21: Else (P94) ;Otherwise, if a sensor scaled frequency
;< -999, i.e. = -1000
22: If (X<=>F) (P89)
1: 1 -- X Loc [ ES1_SF_1 ]
2: 4 <
3: -999 F
4: 30 Then Do
23: Z=F x 10^n (P30) ;Set water content data to -99999
1: -99999 F
2: 0 n, Exponent of 10
3: 9 -- Z Loc [ ES1_WC_1 ]
11