CSBUOY-NS Revision: 11/08 C o p y r i g h t © 2 0 0 2 - 2 0 0 8 C a m p b e l l S c i e n t i f i c , I n c .
Warranty and Assistance The CSBUOY-NS is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under normal use and service for twelve (12) months from date of shipment unless specified otherwise. Batteries have no warranty. CAMPBELL SCIENTIFIC, INC.'s obligation under this warranty is limited to repairing or replacing (at CAMPBELL SCIENTIFIC, INC.'s option) defective products.
CSBUOY-NS Shipping List Items packaged with the CSBUOY-NS for shipment include: • CSBUOY-NS (See Figure 2-1) • Solar panel with mounting brackets and cable • Lid • Instrument housing with antenna hole plug • Float with two (2) eye-bolts • Float plug unscrewed • Instrument shroud • Instrumentation mounting bracket • CR206 • Antenna with cable • 7 AH battery with cable • Two (2) large desiccant packs • Humidity card • CSBUOY-NS manual • CR206 manual/CD-ROM
This is a blank page.
Special Operating Notes 1. Check the shipping list in the front of the manual and make sure that all the parts checked off the list are with the CSBUOY-NS. If any parts are missing, please contact Campbell Scientific, Inc. (435) 753-2342. 2. When connecting the battery avoid shorting the battery to the CR206. 3. Damage to the electronics will occur if moisture builds up inside the CSBUOY-NS instrument housing. 4. The Heyco pressure fittings seal the cable entry points against water intrusion.
This is a blank page.
CSBUOY-NS Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to specific sections. 1. Introduction...............................................................1-1 1.1 Specifications........................................................................................ 1-1 2. CSBUOY-NS Description .........................................2-1 2.1 System Components ............................................
This is a blank page.
Section 1. Introduction The CSBUOY-NS is programmed to communicate directly with a personal computer operating Device Configuration Utility software and/or as a wireless sensor providing data for other Campbell Scientific dataloggers. A 5-watt solar panel is used to trickle charge the battery. 1.
Section 1. Introduction Solar Panel 1-2 Typical Peak Power: 5W Voltage @ Peak Power: 17.1 Vdc Current @ Peak Power: 300 mA Dimensions: 9.45” (24 cm) length, 10.4” (26.
Section 2. CSBUOY-NS Description The CSBUOY-NS is designed to eliminate the use of hard-wire cable to connect the water quality sensors with the datalogger (CR510, CR10X, CR23X, CR800, CR850, CR1000, CR3000). This manual covers installation, communication, and maintenance. 2.1 System Components 5 W Solar Panel Instrument Housing Mooring Eyebolts 5 W Solar Panel Float Antenna Sensor Shroud CR206 Solar Panel Mounting Brackets FIGURE 2-1. CSBUOY-NS 2.
Section 2.
Section 3. CSBUOY Installation 3.1 Site Selection The site should represent the general area being measured. Placement should allow the buoy to float freely without obstruction from the bottom of the water compound being monitored. The buoy solar panel should not have any obstruction from full sunlight. Keep away from overhanging trees or other obstructions. The solar panel should be angled towards the south to maximize full solar capabilities. 3.
Section 3. CSBUOY Installation This is a blank page.
Section 4. Communication The CSBUOY-NS can be used as a stand-alone monitoring system that communicates directly with the PC, or as a wireless sensor that is integrated with other Campbell Scientific dataloggers (CR510, CR10X, CR23X, CR800, CR850, CR1000, CR3000) with table-based operating systems using the Device Configuration Utility communication protocol. 4.1 Direct Connection to PC In order to communicate with the CSBUOY-NS directly from the PC: 1.
Section 4. Communication Programming Examples The following example allows the CR1000 to communicate with one CSBUOY-NS, measuring the parameters.
Section 4. Communication 4: Sample (P70) 1: 13 2: 1 Reps Loc [ Batt ] For further instruction on programming, please refer to the CR10X manual.
Section 4. Communication This is a blank page.
Section 5. Maintenance The CSBUOY-NS has been engineered to provide many years of reliable service. However, periodic maintenance is required to help ensure that the system performs up to its potential. Equipment must be in good operating condition, which requires a program of regular inspection and maintenance. Routine and simple maintenance can be accomplished by the person in charge of the CSBUOY-NS. 5.1 Instrumentation Maintenance The instrumentation requires a minimum of routine maintenance.
Section 5. Maintenance Each month • Check humidity indicator card (or humidity readings from sensor). Replace desiccant pack and tighten Heyco pressure fittings if needed. Each Year • Check cable for rodent or environmental damage. • Replace humidity indicator card if necessary. Every Three to Five Years • Replace 10162 Humidity Sensor (if being used). General Maintenance 5-2 • An occasional cleaning of the glass on the solar panel will improve its efficiency.
This is a blank page.
Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbellsci.com Campbell Scientific Africa Pty. Ltd. (CSAf) PO Box 2450 Somerset West 7129 SOUTH AFRICA www.csafrica.co.za cleroux@csafrica.co.za Campbell Scientific Australia Pty. Ltd. (CSA) PO Box 444 Thuringowa Central QLD 4812 AUSTRALIA www.campbellsci.com.au info@campbellsci.com.au Campbell Scientific do Brazil Ltda.