Owner manual

CS725 Snow Water Equivalency Sensor

The menus can be switched between English and French. To change the

language setting, key the command .L<Enter>. This will allow the selection of

either English or French. The English version of the Main menu is as follows:

*** LIST OF COMMANDS ****

[.l] Language (French or English)

[.h] Read the current live histogram

[.hp] Display the K and Tl peak positions from the live histogram

[.hl] Display the current histogram in log scale

[.hr] Display results after completionof a manual measurement (histogram,

position and #counts K and TI).

[.e] Same as <h> command , but erases histogram at end of operation

[.a] Special command: define start/stop time limits for one measurement

[.t] Display temperature data in °C

[.d] Display date and time

[.dd] Modify date and time

[.hd] Read back histograms from EPROM according to selected dates

[.f] Read back measurement results from EPROM according to dates

[.fl] Read back the current day measurement results

[.flla] Read back last calculated line result

[.fs] Read back calculated line result in short form ? (Time and EENS

only)

[.p] Display Parameter menu

[.s] Display status and current measurement information

[.0xps] Parameters save to file function

[.0xpr] Parameters recovery from file function

[%Rhard]/[%Rboot] Restart software processor/reboot firmware

[UU] CS725/terminal synchronizing sequence for rates other than 9600 bps

6.4 Detailed Main Menu Command Information

1. [.l]

The [.l] command is used to set the language setting to either French or

English.

The following menu is activated once the [.l] command is received:

[0] Francais

[1] English

Type the number 0 for French or the number 1 for English followed by

<Enter>.