Instruction Manual

CS106 Barometric Pressure Sensor

7.3 Wiring

7.3.1 Datalogger Connection

Before connecting the barometer to the datalogger, a yellow warning label

must be removed from the pigtails. The warning label reminds the user of the

importance of properly connecting the barometer to the datalogger. Wiring is

shown in FIGURE 7-3 and TABLE 7-1.

See Table 3-1 Blue – Pressure (VOUT)

See Table 3-1 Yellow – Signal Ground (AGND)

Continuous 12 VDC Red – 12 VDC (SUPPLY)

See Table 3-1 Black – Power Ground (GND)

Control Port or Excitation Channel Green – Control (EXT. TRIG)

Ground or Analog Ground Clear – Shield (G or AGND)

FIGURE 7-3. CS106 wiring diagram

See TABLE 7-1

See TABLE 7-

Continuous 12 Vdc

See TABLE 7-

Control Port or Excitation Channel

Ground or Analog Ground