Instruction Manual

CS106 Barometric Pressure Sensor

5. Under the Available Sensors and Devices list, select Sensors |

Meteorological | Barometric Pressure folder. Select CS106 Barometric

Pressure Sensor. Click to move the selection to the Selected device

window. Enter the Sea Level Elevation Correction. The default units

for the sea level elevation correction is meters; this can be changed by

clicking on the Elevation Correction Units box and selecting Feet.

Defaults for the barometric pressure measurement and frequency of the

measurement are mmHg and Hourly, consecutively. These can be

changed by clicking the Barometric Pressure and Measure sensor boxes

and selecting different values.

6. After selecting the sensor, click at the left of the screen on Wiring

Diagram to see how the sensor is to be wired to the datalogger. The

wiring diagram can be printed out now or after more sensors are added.