User Manual

DataView II (CD295) Dual Line Display

If you are fitting the CD295 door kit, only 3 bolts are required to

be fitted at this step. The bolt in the top-left corner of the CD295

front panel is not required. In this case, only fit the remaining

three bolts, and use the longer (30 mm) bolt supplied in the door

kit in the top-left hole. Do not over tighten as this will cause

damage to rubber washer.

NOTE

See Appendix A for the assembly diagram for the CD295 door kit.

6. Shipping Kit

The CD295 DataView II Shipping Kit includes:

• CD295 DataView II display

• CD295 programming cable

• PC295 software on CD

• CD295 Manual

• CD295 Mounting Template

• 4 x stainless steel mounting screws, dome nuts, stainless steel and rubber

washers.

If the CD295 is to be mounted in the front door of an enclosure, the CD295

door kit will also be included. This kit includes:

• CD295 stainless steel door

• stainless steel screw with nylon spacer, PTFE, rubber and stainless steel

washers, and “nylock” nut

• CD295 door mounting diagram