Owner's manual

ManualsBrandsCampbell Scientific ManualsMeasuring instruments43347 RTD Temperature Probe and 43502 Aspirated Radiation Shield

Table Of Contents

Revision and Copyright Information
Warranty
Assistance
Table of Contents
1. General
2. Specifications
3. Installation
- 3.1 Siting
- 3.2 Assembly and Mounting
- 3.3 43502 Radiation Shield Installation
- 3.4 41003-5 Radiation Shield Installation
4. Wiring
- 4.1 43347-VX Temperature Probe Wiring
- 4.2 43502 Aspirated Radiation Shield Wiring
5. Datalogger Programming for the 43347-VX Probe
- 5.1 Programming for Calibrated 43347-VX Probes
  - 5.1.1 CR1000 Example for Calibrated 43347-VX Probes
  - 5.1.2 CR10X Example for Calibrated 43347-VX Probes
- 5.2 Programming for Uncalibrated 43347-VX Probes
  - 5.2.1 CR1000 Example for Uncalibrated 43347-VX Probes
  - 5.2.2 CR10X Example for Uncalibrated 43347-VX Probes
6. 43347-IX Measurement using Current Excitation
- 6.1 Wiring
- 6.2 Datalogger Programming
  - 6.2.1 Datalogger Programming for Calibrated 43347–IX Probes
  - 6.2.2 Datalogger Programming for Uncalibrated 43347-IX Probes
- 6.3 Resistance Measurement Instruction Details
  - 6.3.1 Determining the Excitation Current
  - 6.3.2 Reducing Measurement Noise
7. Maintenance
8. 43347 RTD Temperature Probe Calibration
9. Manufacturer’s Information
10. Troubleshooting
11. References
Appendix A. Example CR10(X) Program for Ice Bath Calibration
Appendix B. 43502 Aspirated Radiation Shield
Appendix C. 43347 Aspirated Radiation Shield
- C.1 Specifications
- C.2 Installation
Appendix D. Measure Two 43347-IX Probes Using One Current Excitation Channel
- D.1 Wiring
- D.2 Example Program for two Calibrated 43347-IX Probes
Campbell Scientific Companies

43347 RTD Temperature Probe, 43502 and 41003-5 Radiation Shields

41003-5 Shiel

PN 27251 Split Nut

43347 Probe

FIGURE 3-3. 41003-5 Radiation Shield mounted to tripod mast

41003-5 Shield

PN 27251 Split Nu

CM200-series

Crossarm

FIGURE 3-4. 41003-5 Radiation Shield mounted to a CM200-series

Crossarm