Owner's manual

R.M. Young Wind Sentry

3.1 Ships With List

The 03002 Wind Sentry ships with:

(1) 03002 Wind Sentry including

03102 anemometer

03302 vane

crossarm

band clamp (pn 4919)

(1) 12" x 1.0" unthreaded aluminium pipe (pn 3659)

(1) Allen wrench (pn 5201)

The 03101 anemometer ships with:

(1) 03101 anemometer

(1) 10" x 3/4" threaded galvanized pipe (pn 12243)

(1) Allen wrench (pn 5201)

The 03301 Vane ships with:

(1) 03301 vane

(1) 10” x 3/4” threaded galvanized pipe (pn 12243)

(1) Allen wrench (pn 5201)

4. Quickstart

4.1 Step 1 — Mount the Sensor

This quick start is for the 03002 wind set. Refer to Section 7, Installation, if

installing just the 03101 anemometer or 03301 vane. Section 7, Installation,

also provides siting information.

Tools required:

• 5/64” Allen wrench

• Allen wrench provided with sensor

• 1/2” open end wrench

• compass and declination angle for the site (see Appendix A)

• small screw driver provided with datalogger

• UV resistant cable ties

• small pair of diagonal-cutting pliers

• 6 – 10” torpedo level

Install the 03002 using:

• Standard 1.0-in. IPS schedule 40 pipe (pn 3659)

• CM220 Right-Angle Mounting Kit (FIGURE 4-1 and FIGURE 4-2),

• 17953 1 x 1 inch NU-RAIL Crossover Fitting (FIGURE 4-3)