Owner's manual

R.M. Young Wind Sentry

7.2 Assembly and Mounting .2 Assembly and Mounting

Tools required: Tools required:

• 5/64” Allen wrench • 5/64” Allen wrench

• Allen wrench provided with sensor • Allen wrench provided with sensor

• 1/2” open end wrench • 1/2” open end wrench

• compass and declination angle for the site (see Appendix A) • compass and declination angle for the site (see Appendix A)

• small screw driver provided with datalogger • small screw driver provided with datalogger

• UV resistant cable ties • UV resistant cable ties

• small pair of diagonal-cutting pliers • small pair of diagonal-cutting pliers

• 6 - 10” torpedo level • 6 - 10” torpedo level

7.2.1 03002 Wind Sentry Set 7.2.1 03002 Wind Sentry Set

The 03002 mounts to a standard 1.0 in. IPS schedule 40 pipe (1.34 in. O.D.).

A 12” long mounting pipe ships with the 03002. The mounting pipe typically

fastens to a CM200-series crossarm via the CM220 mount or 17953 NU-RAIL

fitting. Section 4, Quickstart, describes mounting the 03002 using a CM220

mount or a 17953 NU-RAIL fitting. The 03002 can also be mounted at the top

of a CM110, CM115, or CM120 tripod with the CM216 (see FIGURE 7-1).

The 03002 mounts to a standard 1.0 in. IPS schedule 40 pipe (1.34 in. O.D.).

A 12” long mounting pipe ships with the 03002. The mounting pipe typically

fastens to a CM200-series crossarm via the CM220 mount or 17953 NU-RAIL

fitting. Section 4, Quickstart, describes mounting the 03002 using a CM220

mount or a 17953 NU-RAIL fitting. The 03002 can also be mounted at the top

of a CM110, CM115, or CM120 tripod with the CM216 (see FIGURE 7-1).

FIGURE 7-1. The CM216 allows an 03002 or 03101 to mount atop the

mast of a CM110, CM115, or CM120 tripod

Fits in Mast

7.2.2 03101 Anemometer

Install the cupwheel to the anemometer shaft using the Allen wrench provided

with the sensor.

The 03101 mounts to a threaded 0.75 in. IPS schedule 40 pipe (1.05 in. O.D.).

A 10 in. long mounting pipe ships with the 03101. The mounting pipe

typically fastens to a CM200-series crossarm via the CM220 mount (see

FIGURE 4-1 in Quickstart) or 1049 NU-RAIL fitting (FIGURE 7-2). The