SDS

Revised: 03/04/15 SLIPKOTE 100 Compressor Oil Page 2 of 7
SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS
SUBSTANCES
CHEMICAL NAME
CAS NUMBER
%
Hydrotreated Heavy Paraffinic Distillates
Zinc Dialkyldithiophosphate Additive
64742-65-0
68649-42-3
99
1
SECTION 4: FIRST AID MEASURES
DESCRIPTION OF NECESSARY FIRST AID MEASURES
EYE CONTACT:
Flush eyes with large amounts of water for 15 minutes. If eye irritation develops or persists get medical help.
SKIN CONTACT:
Remove contaminated clothing. Wash affected area with a waterless hand cleaner, and/or soap and water. If
irritation persists, consult a physician.
INHALATION:
Remove to fresh air. Get medical attention if symptoms persist.
ASPIRATION:
If there is any suspicion of aspiration into the lungs obtain medical advice.
INGESTION:
If the material is swallowed, get immediate medical attention—Do not induce vomiting.
NOTES TO PHYSICIAN:
This material, if aspirated into the lungs, may cause chemical pneumonitis; treat the affected person
appropriately.
SECTION 5: FIRE-FIGHTING MEASURES
FLASH POINT:
> 450 °F
FLASH POINT METHOD:
COC
BURING RATE:
Not determined.
LOWER FLAMMABLE LIMIT (LFL):
Not determined.
UPPER FLAMMABLE LIMIT (UFL):
Not determined.
FLAMMABILITY CLASSIFICATION:
Not determined.
EXTINGUISHING MEDIA:
Dry chemical, foam, carbon dioxide, water fog. Water may be ineffective in fighting an oil fire
unless used by experienced fire fighters.
GENERAL FIRE HAZARDS:
Fire and explosion hazards are moderate when this product is exposed to heat or flame
HAZARDOUS COMBUSTION
PROCEDURES:
Carbon monoxide and carbon dioxide. Decomposition of this product may yield oxides of sulfur
and nitrogen. Decomposition of this product may yield oxides of phosphorus.
FIRE-FIGHTING
EQUIPMENT/INSTRUCTION:
Do not point solid water stream directly into burning oil to avoid spreading. Wear full set of
protective equipment including chemical goggles and gloves.
SECTION 6: ACCIDENTAL RELEASE MEASURES
CONTAINMENT PROCEDURES:
Contain the discharge material. Eliminate all sources of ignition or flammables that may come into
contact with a spill of this material.
CLEAN-UP PROCEDURES:
Absorb with inert absorbent such as dry clay, sand, or diatomaceous earth. Scoop up used absorbent
into drums. Dispose of spent absorbent in an approved industrial waste landfill. Do not allow the
spilled product to enter public drainage system or open water courses. Thoroughly wash the area after
a spill or leak clean-up.
EVACUATION PROCEDURES:
Isolate area. Keep unnecessary personnel away.