User manual

10
Cleanup
CLEANUP FOR OVERNIGHT STORAGE
NOTE: Cleaning and maintenance
of the pump are the most important
steps you can take to ensure proper
operation and a long life for your
airless paint sprayer. Please follow the
cleaning instructions carefully and . . .
WEAR ALL NECESSARY
SAFETY GEAR
NECESSARY TOOLS / MATERIALS:
• One (1) bucket
• Water
• Plastic wrap
When reusing the
sprayer with the
SAME PAINT the next day at the SAME
JOB SITE, it is not necessary to flush
the paint from the system. However,
IT IS IMPORTANT TO KEEP AIR FROM
COMING INTO CONTACT WITH THE
PAINT.
NOTE: Do NOT disconnect any hoses.
1. Turn prime/spray control to PRIME
position.
High pressure
hose may still be
pressurized with prime/spray control
in the PRIME position. With the gun
pointed in a safe direction, pull the
gun trigger to relieve any pressure in
the hose.
2. Engage gun trigger lock.
3. Place spray gun in bucket of water.
There should be enough water to
COVER spray tip. This will prevent
paint from drying or clogging tip.
4. Leave suction and bypass tubes in
bucket of paint. Make sure ends
of suction and bypass tubes are
BELOW surface of paint in bucket.
5. Cover bucket and tubes with plastic
wrap or a damp towel to prevent
film forming on paint. Or, if using
latex paint, pour a very thin layer of
water over top of paint. Stir water
into paint the next morning.
Airless Paint Sprayers
Operating Instructions and Assembly Instructions
Turn Prime/Spray
Control to PRIME
Position
1
3
Place Gun in
Water
Latex Paint: Use Thin Layer of
Water to Cover Paint
www.chpower.com
5
Engage Trigger Lock
Cover Bucket
2
Suction and Bypass Tubes
Remain in Bucket with Ends
Below Paint Surface
4
or
PAINT
PAINT
10
Temporary Cleanup
To Lock Locked
Water