MSDS

SECTION 4- First Aid Measures
Eye Contact: Flush eyes with large amounts of water for 15 minutes. If eye irritation develops or persists
get medical help.
Skin Contact: Remove contaminated clothing. Wash affected area with a waterless hand cleaner, and/or
soap and water. If irritation persists, consult a physician.
Inhalation: Remove to fresh air. Get medical attention if symptoms persist.
Aspiration: If there is any suspicion of aspiration into the lungs obtain medical advice.
Ingestion: If the material is swallowed, get immediate medical attention—Do not induce vomiting.
Notes to Physician: This material, if aspirated into the lungs, may cause chemical pneumontits; treat the
affected person appropriately.
SECTION 5- Fire-Fighting Measures
Flash Point: >450°F
Flash Point Method: COC
Burning Rate: Not determined
Lower Flammable Limit (LFL): Not determined
Upper Flammable Limit (UFL): Not determined
Flammability Classification: Not determined
Extinguishing Media: Dry chemical, foam, carbon dioxide, water fog. Water may be ineffective in
fighting an oil fire unless used by experienced fire fighters.
General Fire Hazards: Fire and explosion hazards are moderate when this product is exposed to heat or
flame
Hazardous Combustion Procedures: Carbon monoxide and carbon dioxide. Decomposition of this
product may yield oxides of sulfur and nitrogen. Decomposition of this product may yield oxides of
phosphorus.
Fire-Fighting Equipment/Instruction: Do not point solid water stream directly into burning oil to avoid
spreading. Wear full set of protective equipment including chemical goggles and gloves.
SECTION 6- Accidental Release Measures
Containment Procedures: Contain the discharge material. Eliminate all sources of ignition or
flammables that may come into contact with a spill of this material.
Clean-Up Procedures: Absorb with inert absorbent such as dry clay, sand, or diatomaceous earth. Scoop
up used absorbent into drums. Dispose of spent absorbent in an approved industrial waste landfill. Do not
allow the spilled product to enter public drainage system or open water courses. Thoroughly wash the area
after a spill or leak clean-up.
Evacuation Procedures: Isolate area. Keep unnecessary personnel away.
Special Instructions: Wear appropriate protective equipment and clothing during clean-up. Surfaces may
become slippery after spillage.
Spill to Navigable Waters: If this material is spilled into navigable waters and creates a visible sheen, it
is reportable to the Nation Response Center.
SECTION 7- Handling and Storage
PROCEDURES FOR HANDLING: Avoid getting this material into contact with your skin and eyes.
Avoid the generation of oil mists. Wash hands after handling and before eating. Keep this product from
heat, sparks, or flames.
RECOMMENDED STORAGE METHODS: Keep the container tightly closed and in a cool, well-
ventilated place. When using this material, do not eat, drink or smoke. Do not store this material in open
or unlabeled containers. Store away from strong oxidizers.
2