Operating Guide
GREASE BUCKET
1. Hang grease bucket from tube as shown in Fig 13.
ASH CUP
GREASE BUCKET
ASH CUP
FIG. 13
ASH CUP
1. Install Ash Cup as shown in Fig 13. Never use grill without
Ash Cup in place.
INSTALL DRIP TRAY
1. Install heat deflector as shown on top of the two guide
rods. Route the pull rod through the hole on the left side
and install the jam nut and the grill knob. Tighten jam nut
against the knob to tighten in place.
2. Install the Drip Tray as shown in Fig 14 and Fig 15.
HEAT DEFLECTOR (1)
PG24SG-2
PULLOUT KNOB (3)
PG24-9
PULL ROD (1)
PG24SG-3
SLIDE ROD (2)
PG36SGX-2
M8 X 1 JAM NUT (1)
DRIP TRAY (1)
PG36SGX-1
FIG. 14
DRIP TRAY
FIG. 15
COOKING GRATES
1. Install the Cooking Grates as shown in Fig 16.
LOWER GRATE (2)
PG24-70
LOWER GRATE (1)
PG36-21
UPPER COOKING RACK (2)
PG36SGX-7
FIG. 16
CLEAN-OUT PORT KNOB
1. Clean-out Port knob must be pushed in when grill is on.
Make sure pullout lock is pushed down and locks the knob to
prevent inadvertent opening of the clean-out port. See Fig 17.
2. Lift pullout lock and pull clean-out port knob to empty ash
into ash cup. See Fig 18.
3. See instructions for burner clean-out.
CLEANOUT PORT CLOSED
CLEANOUT PORT OPEN
FIG. 17
CLEANOUT PORT CLOSED
CLEANOUT PORT OPEN
FIG. 18
HOPPER CLEAN-OUT KNOB ASSEMBLY INSTALLATION
Hand tighten the hopper clean-out knob as shown in Fig. 19.
PG24-9 (1)
PULLOUT KNOB
FIG. 19
DANGER
Never Operate the Pellet grill without the ash cup in place.
Make sure the burner clean-out port is closed and locked
before starting the grill.
WARMING RACK
COOKING GRATE
CLEANOUT PORT KNOB
CLEANOUT PORT KNOB
Never open the burner clean-out port when the grill is hot.
After cleaning out the burner make sure to close the burner
clean-out by pushing the clean-out port knob in on the right side
of the grill. Make sure to lift the pullout lock and push the clean-
out port knob all the way in and lock in place with the pullout
lock. Every 50 hours of use, remove the grill grates, grease tray,
and heat deflector and clean the inside of the grill. If you notice a
lot of ash blowing around in the grill it is time to vacuum it out.
FILLING THE AUGER TUBE
CAUTION: ONLY USE THE FEED SETTING WHEN HOPPER HAS RUN
OUT OF PELLETS. FEED SETTING IS NOT FOR NORMAL USE.
The first time you use your grill or any time the hopper has ran
out of pellets you will need to fill the auger tube. This simply
means you must fill the auger tube with pellets until pellets