Operating Guide
M8 X 60 BOLT
M8 FLANGE NUT
M6 X 15 SCREW
CHIMNEY GASKET
M6 NUT
M6 X 76 BOLT
FIG. 3
4. The height of the chimney cap can be adjusted for summer
and winter. In the summer the gap should be approximately
1-1/2”. In the winter the gap should be approximately ½”.
5. Tighten all hardware.
INSTALL HANDLE
1. Install the handle as shown in Fig 4.
2. Tighten all hardware.
PG24-57 (1)
HANDLE
PG24-59 (2)
M6 HANDLE SCREW
PG24-58 (1)
HANDLE DEFLECTOR
PG24-71 (2)
HANDLE BEZEL
FIG. 4
INSTALL HOPPER HANDLE
1. Install hopper handle as shown in Fig. 5.
FIG. 5
INSTALL HOPPER GUARD AND LID
1. Install guard and lid as shown in Fig. 6. The tab on the
hopper should be inserted into the slot on the guard. Use
screws to secure hopper guard and lid to the hopper.
ASSEMBLY INSTRUCTIONS
Remove all loose parts from the inside of the grill and hopper.
Lay a blanket or piece of cardboard down to protect the grill.
ATTACH THE LEGS
With the help of another person flip the grill upside down on the
blanket or cardboard. The grill lid and hopper lid will swing open
when doing this so be careful not to damage the lids. The grill
may also want to roll on its lid so one person should hold the
grill steady while the other person assembles the bottom legs
and wheels.
1. Lay the grill on its back.
2. Install each of the 4 legs as shown in Fig 1. Make sure the
legs with wheels are attached to the right side of the grill with
the wheels facing out. Note: Front legs are marked with an F
and back legs are marked with a B.
3. Stand the grill upright
4. Tighten all hardware.
M8 X 20 BOLT
M8 LOCK WASHER
FIG. 1
ATTACH BOTTOM SHELF
1. Install bottom shelf as shown in Fig. 2 by installing
hardware in each of the 4 corners.
2. Tighten hardware.
M8 X 60 BOLT
M8 FLANGE NUT
FIG. 2
ATTACH CHIMNEY AND CHIMNEY CAP
1. Install chimney to grill as shown in Fig 3. Make sure to
install the gasket between the grill and the chimney.
2. Tighten all hardware.
3. Install M6 x 76 Bolt through chimney cap and secure
using Qty (1) M6 nut. Thread second nut onto bolt leaving
approximately 1.5” to the top of the cap. Thread cap
assembly down into the chimney bracket until the lower nut
hits the bracket. See Fig 3.