Instructions / Assembly

GREASE BUCKET
1. Hang grease bucket from tube as shown in Fig 6.
ASH CUP
1. Install Ash Cup as shown in Fig 6. Never use
grill without Ash Cup in place.
ASH CUP
GREASE BUCKET
FIG. 6
INSTALL DEFLECTOR AND DRIP TRAY
1. Install the Heat Deflector and Drip Tray as
shown in Fig 7 and Fig 8.
FIG. 7
HEAT DEFLECTOR
DRIP TRAY
FIG. 8
HEAT DEFLECTOR
DRIP TRAY
WARMING RACK AND COOKING GRATE
1. Install the Warming Rack and Cooking Grate as
shown in Fig 9.
FIG. 9
PG24-1
WARMING RACK
PG24-70 (2)
COOKING GRATE
CLEAN-OUT PORT KNOB
1. Clean-out Port knob must be pushed in when
grill is on. Make sure pullout lock is pushed
down and locks the knob to prevent inadvertent
opening of the clean-out port. See Fig 10.
2. Lift pullout lock and pull clean-out port knob to
empty ash into ash cup. See Fig 11
3. See instructions for burner clean-out.
FIG. 10
CLEANOUT PORT CLOSED
CLEANOUT PORT OPEN
FIG. 11
CLEANOUT PORT CLOSED
CLEANOUT PORT OPEN
BURNER CLEAN-OUT
Before each use the burner should be cleaned out
by lifting the pullout lock and pulling the clean-out
port knob on the right side of the grill to open the
burner clean-out. This will allow the ash from
previous use to fall into the cup under the grill.
The cup should be removed and emptied and then
reinstalled before each use.
DANGER
Never Operate the Pellet grill without the ash
cup in place.
Make sure the burner clean-out port is closed
and locked before starting the grill.
WARMING RACK
COOKING GRAT E
CLEANOUT PORT KNOB
CLEANOUT PORT KNOB
Never open the burner clean-out port when the
grill is hot.