Instructions / Assembly

7
2. Be sure regulator is tightly connected to
LP tank.
3. Slowly open LP tank valve by turning hand
wheel counter clockwise. If you hear a
rushing sound, turn gas off immediately.
There is a major leak at the connection.
Correct the leak before proceeding.
4. Brush 50/50 soap and water solution to all
gas carrying connections and fittings.
5. If “growing” bubbles appear, there is a
leak. Close LP tank valve immediately and
retighten connections. If leaks cannot
be stopped, do not try to repair. Call for
replacement parts. Order new parts by
giving the serial number, model number and
name of items needed to the Service Center
at 1-435-752-3922.
6. Always close LP tank valve after
performing tank leak test by turning hand
wheel clockwise.
WARNING
• Do not use appliance until leak checked.
• If you cannot stop a gas leak, immediately
close LP tank valve and call LP gas supplier
or your fire department!
HOSE CHECK
• Before each use, check to see if hoses
are cut or worn. Replace damaged hose
assembly before using appliance. Use
only valve/hose/regulator specified by
manufacturer. See product sheet for hose &
regulator information.
CAUTION
The burner must be inspected before
each use of the appliance. If it is evident
that the burner is damaged it must be
replaced before the appliance is put into
use. The burner must be replaced only by
factory authorized parts as specified by the
manufacturer.
OPERATING INSTRUCTIONS
Lighting Procedures
1. Check all connections
for leaks using the
“soapy water” test.
2. Check for any
blockage to the
venturi tube or
burner. Remove any
foreign objects or
matter.
3. Be sure the burner control knob is “OFF”.
4. Open the LP cylinder valve ONLY 1-1/2
turns by turning counterclockwise.
5. Insert a long-nose gas lighter next to the
burner, making sure it sits over the burner.
Open the valve next to the burner by turning
the lever to the ON position. If the burner
does not light within 4 or 5 seconds, turn
the control knob off, wait 5 minutes, and
repeat the process.
CAUTION
The fire pit can become very hot while in
use. Do not touch any portion of the fire
pit except for the control knob next to
the regulator. It may be necessary to use
protective gloves.
SHUTTING THE FIRE PIT OFF
Turn the control knob off and the burner flame
should then go out. Turn off the LP cylinder
valve by turning the knob clockwise until it
stops. Follow instructions in this manual for
proper storage procedures and the important
warnings and safe guards on pages. When an
LP tank is not connected, and to help prevent
dirt or other foreign particles from clogging
the HVR, hang the end of the HVR hose from
the outer ring.
CONTROL VALVE
OFF
ON