Instruction Manual

ManualsBrandsCamp Chef ManualsStovesCS14

14” x 24” Wall Tent Stove

Model – CS14

Recommended Tent Size - 10’ x 12’ Min – 14’ x16’ Max

WARNING:

Failure to follow the instructions in this

manual could result in damage, injury, or death.

Read all instructions before using this stove.

Summary of content (6 pages)

PAGE 1
4” x 24” Wall Tent Stove Model – CS14 Recommended Tent Size - 10’ x 12’ Min – 14’ x16’ Max WARNING: Failure to follow the instructions in this manual could result in damage, injury, or death. Read all instructions before using this stove.
PAGE 2
WARNING: Tent wood stoves are designed for use in tents and outside only. Do not use stove in a cabin, workshop, etc. Insure you have fireproof material underneath the stove and have proper heat standoff distance from walls. WARNING: Keep all flame and heat sources away from the tent fabric. Many tents are flame resistant. This does not mean they are fire proof. The material will burn if left in continuous contact with a flame source. Do not insert the stove pipe directly through the fabric.
PAGE 3
Setup Instructions Always ensure your stove is on a level surface to avoid any possible problems. Have a nonflammable area in front of your stove in case sparks or wood falls out of your stove when you open the door. This stove is designed so all accessories including an option water tank may be stored inside of the fire box. 1. Remove all components from the inside of the fire box. 2. Turn the stove upside down and install the legs. Tighten the wing screw on each leg to hold in place. 3.
PAGE 4
6. Installing the damper - There are 5 sections to the chimney. Each gets larger in diameter as they go up. The first section has two holes for installing the damper. First remove the wire rod from the damper. Hold the damper down inside the chimney and insert the rod first through the hole in the pipe, through the damper, and out the hole on the opposite side of the pipe. Take note that when damper rod handle is horizontal the damper is closed. When the damper rod handle is vertical the damper is open. 7.
PAGE 5
Warning: Before using the stove in the tent for the first time the paint must be properly cured. Curing the paint - Set your new stove up in your backyard or driveway and burn wood in the stove for 1-2 hour to cure the paint. Using the damper supplied with the stove is strongly recommended. A damper makes your stove 10-15% more efficient reducing the amount of wood you have to cut by 10-15% if you use a damper.
PAGE 6
The more you damper the stove pipe down or/and reduce the air intake on the stove door the more creosote build up you will have in the stove pipe and spark arrestor. If you get too much creosote in the stove pipe you can possibly have a fire in your stove pipe. When breaking camp, remove the creosote in your stove pipe by gently banging the stove pipes together to loosen the creosote. It is normal to periodically clean the spark arrestor every 2-3 days.