Instructions / Assembly

CART AXLE

(1)

3-CCH-10

CART WHEEL

(2)

3-CCH-11

1/2" FLAT WASHER

(1)

AXLE COTTER PIN

(1)

COTTPIN

Step 1: Turn stove upside down. Slide leg attachment with axle holes

into the left cart leg sockets.(Stove knobs should be facing you

to determine correct orientation) Slide the button head bolt

through the legs and attach to the cart with the nyloc nut. Repeat

step on all legs. Tighten nuts just enough to keep legs from

rotating freely.

Step 2: Slide the cart axle through one wheel and cart legs. Attach the

remaining wheel and the 1/2” ﬂat washer. Secure the cart axle

with the axle cotter pin.

Step 3: Stand stove upright. Attach bottom tray as shown. (Figure 3)

NOTE: Legs should be pressed out to put pressure on legs when

tightening knobs.

SETUP INSTRUCTIONS

3/8" X 1.75"

BUTTON HEAD BOLT

(4)

3/8" NYLOC

NUT (4)

LEG WITH AXLE HOLE

MUST BE ON LEFT

SIDE

Figure 1

Figure 2

Figure 3

BOTTOM TRAY

(1)

5/16 X 1.25

KNOB (2)

3-CCH-12

SEE DETAIL A

PAGE 1
SETUP INSTRUCTIONS LEG WITH AXLE HOLE MUST BE ON LEFT SIDE Figure 1 3/8" X 1.75" BUTTON HEAD BOLT (4) 3/8" NYLOC NUT (4) Step 1: Turn stove upside down. Slide leg attachment with axle holes into the left cart leg sockets.(Stove knobs should be facing you to determine correct orientation) Slide the button head bolt through the legs and attach to the cart with the nyloc nut. Repeat step on all legs. Tighten nuts just enough to keep legs from rotating freely.
PAGE 2
1/4" X 1/2" LONG BUTTON HEAD SCREW (8) 1/4" LOCK WASHER (8) SHELF BRACKET (4) 3-CCH-6 Step 4: Attach shelf brackets by aligning the bracket on the cart legs and inserting the lock washer and button head screw. (See Figure 4) Step 5: Attach regulator hose to mip. Tighten using wrench. Perform soap and water test to check for leaks. Step 6: Assemble side shelves by inserting hook over the bottom rod in the brackets assembled in step 4. Lift shelf up and rotate into upper rod.