Operation Manual

04
Installation and Management
Caution
Before use the product, check if operation and video recording goes well.
Installation and Management
• Keep the camera lens clean by preventing dust or foreign substance from coming into contact with the lens.
Otherwise, this may result in video distortion. If another object is placed nearby it may be reflected in the window.
So keep the area clear around the installed Camera.
• If installation location of the product is changed, it may not record properly even if it worked after initial installation.
Therefore, install the product firmly and do not give an excessive shock or force to move the product.
• Continuous change of product location from the windshield may cause weakening of adhesive strength and the product
can fall off in the end.
• Check that position of SD card is correct before inserting.
• In the case of using the power from the vehicle (DC fused power), please disconnect the power cable
if you do not use the product for a long time. (It may cause discharge the battery.)
• Do not switch power off while firmware is upgrading. It may cause malfunctioning.
• Long term use of this product or in case of severe vibration may cause change in camera angle.
Correct the angle or location of product on a flat location whilst parked.
• Do not use chemicals or detergents to clean the product. This can result in a malfunction.
• Never cause excessive shock to or inject a foreign substance into the product.
Causing excessive force or shock or injecting a foreign substance into this product can cause malfunction.
• Avoid high temperature (direct sunlight) or high humidity during normal operation of product.
• Do not disassemble or repair this product.
It can cause malfunction and such action will result in the product being void of all warranty/service provisions.