User guide

 User Guide
Page 51
Basic Installation for Local and Remote Monitoring
Setup Procedure
1.
Connect cameras to  RX {Video Input} with RG59 cable and BNC connector.
Note: The camera system is either NTSC or PAL and all cameras must have the SAME
system format.
2. Connect CCTV monitor to  RX {Video Output} with RG59 cable and BNC
connector.
3. Install and use the bundled key to lock the {Hard Disk Rack} with hard disk to the
 RX.
Note: If there is no hard disk installed, Recording or Playback is not functional during live
video monitoring.
4. Connect the power adapter (12V DC) to the  RX.
5. Turn on the power of  RX, camera and monitor. Check the {Power LED} ,
which is lit up in blue color continuously at  RX front panel after power on.
After several seconds, live video appears on the CCTV monitor as follows:
Note: Please go through the following steps (6-10) if the video of CCTV monitor does not show
clearly.