User guide

 User Guide
Page 49
Basic Installation for Local and Remote Monitoring
14.
Configure the network setting for  RX
video recording server and your PC if necessary,
such as router/gateway port mapping (select
router/gateway IP as IP provided by your ISP and
the video recording server IP as IP provided by the
router/gateway), firewall, etc. (Please refers to the
manual of your router/gateway.)
15. Run WX-30 software at any network PC. (For
details of WX-30 software installation, please refer
to WX-30 Software Guide)
16. Press [Connect] icon to pop up the [Connect
Window]. For example, type and select the
following setting :
Broadband Connection :
Phone/IP :
www.your_site.your_company.TeleEye.net
Connect Using : TCP/IP Broadband
Password : 000000
OR
Narrowband Connection :
Phone/IP :
www.your_site.your_company.TeleEye.net
Connect Using : TCP/IP Narrowband
Password : 000000
If RX is set to advanced security mode, check
Advanced security mode box and enter User
Name
17. Press [Connect] icon to connect your
PC and the video recording server. The video
appears on the WX-30 if success. Otherwise, the
[Warning] board will pop up and the failure
message will be shown. For failure case, please
press [Connect] icon to check that the
connection setting is valid or not.