User guide

 User Guide
Page 45
Basic Installation for Local and Remote Monitoring
11.b.1.
In Windows 2000/XP desktop, select Start >
Control Panel
11.b.2. Double click Network and Dial-up
Connections > right click Local Area
Connections and choose Properties.
11.b.3. Choose Internet Protocol (TCP/IP) and click
Properties
11.b.4. Enter an IP address, subnet mask and Default
gateway.
Note: IP address should be “192.168.0.xx”
except “192.168.0.2” which is  RX
default IP address.
11.b.5.
Enter the Preferred and Alternate DNS server, if
necessary.
11.b.6. Click OK to activate the new IP.
You have to confirm that IP address has been
correctly set on your computer. On your
windows, click start > run, type “cmd” at
Open field and press OK button, then type
“ipconfig” on the DOS prompt, you will see an
IP set on your computer.
11.b.7. Connect the PC Ethernet socket to the video
recording server Ethernet socket at rear panel of
the video recording server with cross-over
Ethernet cable. Check if the {LINK LED} of
the video recording server is ON.
10/100 BASE-T
LINK COL