User guide

 User Guide
Page 39
Basic Installation for Local and Remote Monitoring
14.
Configure the network setting for  RX
video recording server
and your PC if necessary,
such as router/gateway port mapping (select
router/gateway IP as IP provided by your ISP
and the video recording server
IP as IP provided
by the router/gateway)
, firewall, etc. (Please refer
to the manual of your router/gateway.)
15. Run WX-30
software at any network PC. (For
details of WX-
30 software installation, please
refer to WX-30 Software Guide)
16. Press [Connect]
icon to pop up the
[Connect Window]. For example
, type and
select the following setting :
Broadband Connection :
Phone/IP : 210.17.139.145
Connect Using : TCP/IP Broadband
Password : 000000
OR
Narrowband Connection :
Phone/IP : 210.17.139.145
Connect Using : TCP/IP Narrowband
Password : 000000
If RX is set to advanced security mode, check
Advanced security mode box and enter
User
Name
17. Press [Connect]
icon to connect your
PC and the video recording server. The
video
appears on the WX-
30 if success. Otherwise, the
[Warning] board will pop up and the
failure
message will be shown
. For failure case, please
press [Connect] icon
to check that the
connection setting is valid or not.