User guide

  Eye RX User Guide
Page 153
RX-SE setting
4. Select [TEST] option and press “Enter”
button to test the connection of RX-SE. Result
will show in the STATUS. If it shows ERROR
or DISCONNECTED, you should check the
RX-SE connection and the IP address ,port
number or password correct or not. SERIAL
NO and VERSION represent the serial number
and version of RX-SE. It will show after the
RX-SE is connected.
Note:
There are several statuses.
STATUS : MEANING :
DISCONNECTED Disconnected
CONNECTED Normal
INCORRECT PW Incorrect password
SE BUSY The RX-SE is in use
IP/PORT ERROR Cannot establish connection
MOUNT ERROR Testing result : HDD error
READ ERROR Testing result : HDD error
WRITE ERROR Testing result : HDD error
UMOUNT ERROR Testing result : HDD error
VALID Tested OK
5. Select [CONFIGURE] option and press
“Enter” button.
6. Select [PASSWORD] option and press
“Enter” button to change the password.
Note:
RX-SE IP can change here. The IP of RX-SE 1 will
change if you input a new IP.
RX
-
SE 1 SETTING
ENABLE YES
IP 192.XXX.X.X
PORT 1025
PASSWORD ******
TEST ENTER
STATUS CONNECTED
SERIAL NO XXXXX
VERSION XXXXX
CONFIGURE . . .
RX
-
SE 1 SETTING
ENABLE YES
IP 192.XXX.X.X
PORT 1025
PASSWORD ******
TEST . . .
STATUS CONNECTED
SERIAL NO XXXXX
VERSION XXXXX
CONFIGURE . . .
RX
-
SE 1 CONFIG
IP 192.XXX.X.X
PORT 1025
SUBNET 255.XXX.XXX.X
GATEWAY 192.XXX.X.X
PASSWORD . . .