User guide


User
Guide
Page 145
Connection with PTZ cameras
I. Connection with PTZ cameras
As  RX video recording server built with a RS485 IN and OUT port, you can connect
port OUT to Pan/Tilt/Zoom cameras (in parallel) and connect port IN to keyboard controller.
The connection diagram is shown below.
RG59 cable
Power Adapter
  RX
Cameras
CCTV
Monitor
RG59 cable
RS 485 Out : PTZ cameras
RS 485 In : PTZ Controller
2-
wire RS 485
BUS
Setup Procedure
1. Connect the P/T/Z cameras to the RS 485 OUT port in parallel at the  RX rear
panel. Connect the P/T/Z cameras to video input port according to each P/T/Z camera ID.
Note: All P/T/Z cameras should be the same model.
2. Connect the keyboard controller to the RS 485 IN port at the  RX rear panel.
For keyboard controller setup, please refer to the keyboard controller manual.
3. Configure P/T/Z cameras driver and setting through OSD menu by CCTV monitor.
Configure P/T/Z cameras driver and setting as follows:
1. Press “Menu button, select [SETUP] option
and press “Enter button to enter [SETUP]
sub menu. Select [VIDEO] option and press
Enter button.
SETUP
MENU
VIDEO . . .
RECORDING . . .
SWITCHES . . .
DATE / TIME . . .
CONNECTION . . .
EVENT HANDLER . . .
TRANSMITTER . . .
PASSWORD . . .
USER ACCOUNT . . .
RX-SE . . .
SETTING IMPORT/EXPORT . . .
RESTORE FACTORY SETTING ENTER