User guide

 User Guide
Page 134
Event Action
2. Select [ENABLED] option and use “Left”
or “Right”
button to enable (i.e. set the
value to [YES]) buzzer action.
3. Select [GENERAL BUZZER SETTING]
option and press “Enter”
button to enter the
buzzer setting menu.
4. Select [DURATION] option and
press the
“Left” or “Right”
button to choose the
duration.
5. Select [ACTION DELAY]
option and press the
“Left” or “Right”
button to choose the
action delay
6. You can press “Live”
button to exit OSD
menu or press “Back” button to enter act
ion
menu again.
7. Event LED
The event LED is the LED built on the front panel of  RX video recording server .
If an event is triggered, the LED is blinking until the event is cleared.
Event LED Action setup procedure
1. In the action menu, select [EVENT LED]
option and press “Enter” button to enter the
event LED action setting menu.
XXXXXX X BUZZER
ENABLED YES
GENERAL BUZZER SETTING . . .
GENERAL BUZZER SETTING
DURATION 10SEC
ACTION DELAY 10SEC
GENERAL BUZZER SETTING
DURATION 10SEC
ACTION DELAY 10SEC
XXXXXXX ACTION
RECORDING …
SWITCH …
DIALBACK …
EMAIL …
SMS …
BUZZER …
EVENT LED …
LIVE CAMERA …
PTZ …
SPOT ALARM …