Specifications

Page 13
Use Your 1-CCD Presenter Camera System
System Start Up
Once you have made all the necessary connections and configurations, you are ready to start up the rest of the system.
Tracking Ring Package
1. Power ON the CameraMan camera with the POWER switch on the Main Docking Station.
2. Set the Tracking Ring Power Pack's power switch, located on the top of the unit, to the
ON position. The Power ON LED on the Power Pack illuminates.
If the Power ON LED on the top of the Tracking Ring Power Pack does not illuminate,
then refer to the Troubleshooting section of this manual.
3. Verify that the TRACKING UNIT STATUS LED on the camera’s display panel illuminates,
indicating the communication link between the camera and the Tracking Ring.
4. Press one of the four autoTRACK View buttons on the keypad to activate the autoTRACK
functionality of the Camera System (the camera will not track until one of the autoTRACK
buttons is pressed). Once you are in autoTRACK mode, the autoTRACK LED on the
camera’s display panel illuminates.
If the autoTRACK LED on the CameraMan’s display panel is blinking, CameraMan is in the
autoTRACK mode, but the link between CameraMan and the Tracking Ring is not active.
To establish this link, move into the CameraMan’s field-of-view (Please see the autoTRACK
MODE or Troubleshooting sections of this manual for further assistance).
Rechargeable Battery
The Tracking Ring Power Pack comes with a built-in 12-hour Rechargeable Battery. When the
battery is running low, the Battery LOW LED on the top of the Tracking Ring Power Pack
illuminates. At this time the Tracking Ring Power Pack should be recharged or an Auxiliary
Battery Pack should be attached to the Tracking Ring Power Pack.
To recharge the battery:
1. Turn OFF the Tracking Ring Power Pack.
2. Set the switch on the front of the Battery Charger to TRACKING POWER PACK.
3. Plug the Battery Charger into an electrical outlet and connect the Power Pack to the charger.
The Battery Charger takes 2 to 3 hours to recharge the Tracking Ring Power Pack.
The LED on the Battery Charger indicates when the battery is fully-charged. If a battery is very
low, then the LED on the charger flashes slowly. While the battery is charging, the LED on the
charger stays on. When the battery is fully-charged, the LED on the charger flashes faster.
CameraMan display panel
tracking LEDs (ON when active)
Top view of Power Pack
llustrating power switch and ON LED
Top view of Power Pack
illustrating battery LOW LED
Top view of Power
Pack illustrating battery
charger jack
autoTRACK View
buttons on
Keypad
Tracking
Power Pack
switch on back
of battery
charger