Users Manual Part 1

31
DMX
DEUTSCHFRANCAIS
ESPAÑOL
ENGLISH
ITALIANO POLSKI
SYSTEM INFORMATION (System Info)
Starting from the main display, press the right push button rotary encoder to access the menu
for selecting the mode (menu). Rotate the left encoder (SELECT) to SELECT System Info (see left
arrow) and confirm by pressing the left encoder (ENTER).This will take you to the submenu for
calling up the system information (see table, selection by turning the left encoder).
PLEASE NOTE
System Info
Main CPU Vx.xx
DRV CPU Vx.xx
LED temp. xx°F xx°C
Op. hours xxxxx:xx h
Display Always on/off after 20 s
Signal Fail Hold / Blackout / User Colour 8 / Fade Out 10s
Dim Curve Linear / Exponential / Logarithmic / S-Curve
Dim Response LED / Halogen
Red Shift Off / Dim to Warm
PWM 650 Hz / 1530 Hz / 3600 Hz / 12 kHz / 18.9 kHz / 25 kHz
Calibr. RAW / User / Factory / Smart
User calibration R= 000–255
User calibration G= 000–255
User calibration B= 000–255
User calibration W= 000–255
Auto Lock Off / On
Fan Auto / Off / Constant Low / Constant Medium / Constant High
WDMX Off / On
User button 1 EZ Remote / Mode Selection / HSI / Direct / Colour Coordinates
GEL / User Colour / Play Loop / Light Simulation
User button 2 EZ Remote / Mode Selection / HSI / Direct / Colour Coordinates
GEL / User Colour / Play Loop / Light Simulation
RDM UID xx xx xx xx xx xx xx
MAC Addr. xx:xx:xx:xx:xx:xx
In order to be able to access all menu items in the spotlight via the Fixture menu using the Cameo
UNICON DMX/RDM controller, the menu items Stand Alone (with all Stand Alone modes), EZ
Remote and Slave are also in the main menu, except in the Mode menu.