Users Manual Part 1

17
DMX
DEUTSCHFRANCAIS
ESPAÑOL
ENGLISH
ITALIANO POLSKI
MAIN DISPLAY IN THE ARTNET OR SACN MODE
The main display in ArtNet or sACN mode shows the DMX mode, the currently set DMX start
address, the IP address and universe group and the universe (see illustration).
Currently activated operating mode
W-DMX status
DMX mode
DMX start address
IP address
Universe and Group
Press encoder =
Mode selection
Press encoder =
Open the main menu (Menu)
W-DMX™
To pair a W-DMX receiver with a W-DMX-compatible transmitter, W-DMX must be switched on
in the receiver’s settings menu under Wireless Settings (WDMX State -> On), the device must
be configured as a receiver (Operating Mode -> Receive) and the Reset command must be
executed (Receive Reset -> Yes). The receiver is now in pairing standby and waiting for a pairing
request from a transmitter. Start the pairing by selecting Link in the menu of the transmitter and
confirming; the pairing now takes place automatically. In the same way, several receivers can be
paired simultaneously or one after the other to a transmitter (e.g. for master / slave operation).
A W-DMX connection is always maintained until the connection is disconnected by means of the
Reset command in the receiver or the Unlink command in the transmitter, regardless of whether a
device has been disconnected from the power supply in the meantime.
W-DMX
deactivated
W-DMX
as receiver
activated,
not paired
W-DMX
as receiver
activated
and
paired,
Transmitter
switched off
or out of
range
W-DMX
as receiver
activated
and
paired,
no
DMX signal
W-DMX
as receiver
activated
and
paired,
DMX signal
is present
W-DMX
as trans-
mitter
with G3
standard
activated,
DMX signal
is present
W-DMX
as trans-
mitter
with G4s
standard
activated,
DMX signal
is present
W-DMX
as trans-
mitter
with G3
standard
activated,
no
DMX signal
W-DMX
as trans-
mitter
with G4s
standard
activated,
no
DMX signal